Carton Contents; Unpacking And Checking Contents; Assembly And Installation - Promac 349V2 Manuel De L'utilisateur

CARTON CONTENTS

UNPACKING AND CHECKING CONTENTS

Carefully unpack the machine and all its parts, and compare against the illustration following.
WARNING:
• To avoid injury from unexpected starting, do not plug the power cord into a power source receptacle during unpacking and
assembly. This cord must remain unplugged whenever you are assembling or adjusting the machine.
• If any part is missing or damaged, do not plug machine in until the missing or damaged part is replaced, and assembly is
complete.
TABLE OF LOOSE PARTS
Unpack carton; check you machine to see parts listed below:
1. Metal band saw
2. Foot
3. Work stop with lock handle
4. Guide rail with hex nut
1

ASSEMBLY AND INSTALLATION

1. Attach four feet to base.
2. Place the machine on a work bench, secure it by using 3 holes provided on the base.
3. Screw the guide rail to the thread hole on vise base. Tighten the nut to fix it,
4. Attach the work stop to the guide rail, secure it by tightening the lock handle
Foot
X1
X4
X1
X1
Work stop
Guide rail
2
3
16
4