Power Supply (Fig. E); Console (Fig F); Display Functions; Key Functions - Tunturi S40 Sprinter Bike Manuel De L'utilisateur

Power supply (Fig. E)

The trainer is powered by an external power supply.
Refer to the illustration to locate the trainer power
input.
NOTE
• Connect the power supply with the trainer
before connecting it to the wall outlet.
• Always remove power cord when
• machine is not in use.

Console (fig F)

1
3
2
1. Display
2. Tablet/ book support
3. Buttons
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger.
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes. If the
console is in standby mode.

Display functions

Time window :
- Shows workout time during exercise
Range: 0:00 ~ 99:59
Speed window :
- Shows actual speed during exercise
Range: 0.0 ~ 99.9
RPM window :
- Shows revolutions per minute during exercise
Range: 0 ~ 999
Pulse window :
- Shows pulse in bpm during exercise
Distance window :
- Shows workout distance during exercise.
Range: 0.0 ~99.9
Calories window :
- Shows burned calories during exercise
Range: 0 ~999

Key functions

Recovery
- Test heart rate recovery status.
Down
- Decrease resistance level during workout.
- In setting selection lower value.
Mode
- Confirm setting or selection
Up
- Increase resistance level during workout.
- In setting selection upper value.
Reset
- When press and hold for 2 seconds, display will
reboot and start from main menu. (all shown data
will be lost)
- Reverse to main menu during presetting workout
value or stop mode
Start/ stop
- Start workout when in idle mode.
- Stop/ pause workout when in active mode.
1 7
English