Power Supply (Fig. E); Console (Fig F); Explanation Display Functions - Tunturi Cardio Fit Bike E35 Manuel De L'utilisateur

English
Adjusting the horizontal seat position
The horizontal seat position can be adjusted by
setting the seat to the required position.
- Loosen the seat adjustment knob.
- Move the seat to the required position.
- Tighten the seat adjustment knob.
Adjusting the vertical seat position
The vertical seat position can be adjusted by
setting the seat tube to the required position.
With the leg almost straight, the arch of the foot
must touch the pedal at its lowermost point.
- Loosen the seat tube adjustment knob.
- Move the seat tube to the required position.
- Tighten the seat tube adjustment knob.
Adjusting the handlebar
The handlebar can be adjusted according to the
height and the exercise position of the user.
- Loosen the handlebar adjustment knob.
- Move the handlebar to the required position.
- Tighten the handlebar adjustment knob.

Power supply (Fig. E)

The trainer is powered by an external power
supply. Refer to the illustration to locate the
trainer power input.
NOTE
• Connect the power supply with the trainer
before connecting it to the wall outlet.
• Always remove power cord when
• machine is not in use.
16

Console (fig F)

1
3
2
1. Display
2. Tablet/ book support
3. Buttons
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is
covered with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your
finger. Make sure that your nails or sharp
objects do not touch the display.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes.

Explanation Display functions

Time
- Without setting the target value, time will count
up.
- When setting the target value, time will count
down from your target time to 0 and alarm will
sound or flash.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, time will
STOP
- Range 0:00~99:59