HYDAC ELECTRONIC ENS 3000 Notice D'utilisation page 55

ENS 3000 IO-Link
Other data
Max. tank pressure
Supply voltage
Current consumption
Residual ripple of supply voltage
Fluids
Parts in contact with medium
Display
Weight
Note: Reverse polarity protection of the supply voltage, overvoltage, override and and short circuit
protection are provided.
FS ( F ull S cale) = relative to complete measuring range
* Specified for calm, non-turbulent fluid
IO-Link-specific data:
Features
Block Parameters
Data Storage
Profile Characteristic
Supported Access Locks
Communication
IO-Link Revision
Transmission Rate, Baud Rate
Minimum Cycle Time
Process data width
SIO Mode Supported
M-Sequence Capability
* Connection with unshielded standard sensor line possible up to a max. line length
of 20 m.
Download the IO Device Description (IODD) from: →Products→Sensors→Product
Search
http://www.hydac.com/uk-en/products/sensors/show/Material/index.html
Entering the part number (9xxxxx) the corresponding ZIP file appears
Version 2014/12/11
0.5 bar (short-term 3 bar, t < 1 min)
9 .. 35 V DC, if PIN 2 = SP2
18 .. 35 V DC, if PIN 2 = analogue output
max. 420 mA
max. 70 mA
≤ 5 %
Hydraulic oils (mineral based),
synth. oils, fluids containing water
Ceramic
4-digit, LED, 7 segment, red,
height of digits 7 mm
180 .. 300 g, dependent on the probe length
**
Yes
Yes
0x0001 (Device Profile: Smart Sensor),
0x8000 (Function Class: Device Identification),
0x8001 (Function Class: Binary Data Channel),
0x8002 (Function Class: Process Data Variables)
Parameters
Data Storage
Local Parameterisation
Local User Interface
V1.1 / support V1.0
38.4 kBaud * (COM2)
20 ms
Version without temperature sensor:
Version with temperature sensor:
Yes
PREOPERATE:
OPERATE:
ISDU:
HYDAC ELECTRONIC GMBH
total
with inactive switching
output and
analogue output
Other fluids on request
TYPE_0
TYPE_2_2
(level)
TYPE_2_V
(level / temperature)
Supported
page 25
16 Bit
32 Bit
Part No. 669898