Angelo Po B151HU Manuel D'utilisation page 8

– When cleaning and sanitising the appliance with detergents, always wear personal
protection equipment (gloves, masks, goggles, etc.) as required by the relevant health
and safety legislation..
– In the event of lengthy periods out of use, thoroughly clean all internal and external
parts of the appliance and the surrounding area (in accordance with the manufactur-
er's instructions) and disconnect all supply lines.
– During routine use of the appliance, the Operator's constant presence is required.
– Never direct pressurised water jets at external or internal parts of the appliance to
avoid damage to components, especially electrical and electronic parts.
– Do not leave flammable objects or materials close to the appliance.
Important
Installations and/or repairs carried out by unauthorised staff or with non-origi-
nal parts, as with any technical change that is not approved by the manufactur-
er, will void the warranty and relieve the manufacturer of any liability for damage
to the product.
SAFETY WARNINGS FOR ELECTRICAL EQUIPMENT
– The electrical equipment has been designed and constructed in accordance with the
relevant regulations. These regulations consider operating conditions in relation to the
surrounding environment.
– The list specifies the conditions required for the correct operation of the electrical
equipment.
- The room temperature must not be less than 41°F.
- Relative humidity must be between 50% (measured at 104°F) and 90% (meas-
ured at 68°F).
- The place of installation must be immune to electromagnetic interference and ra-
diation (X-ray, lasers, etc.) and must not be a source of these.
- The room must not have areas with concentrations of gas or powders which are
IT
potentially explosive and/or represent a fire hazard.
- The products and materials used during production and maintenance must not
US
contain contaminants or corrosives (acids, chemicals, salts, etc.) and must not be
able to penetrate and/or come into contact with the electrical components.
DE
- During transport and storage, the ambient temperature must be between -13°F
CAN
and 131°F. However, the electrical equipment may be exposed to a temperature of
up to 158°F, provided the exposure time does not exceed 24 hours.
ES
If it is not possible to comply with one or more of the conditions listed, essential for
correct operation of the electrical equipment, agreement must be reached in the con-
tract concerning the additional features required to create the most suitable conditions
(e.g. special electrical components, air-conditioning equipment, etc.).
English - 6 - Use and installation manual