STERILIZATION LAMP INSTALLATION
The sterilization lamp kit is not supplied as standard equipment.
Should you purchase the kit, please follow the installation instructions to install. .
PRINTER INSTALLATION
The printer is not supplied as standard equipment.
Should you purchase the printer, please follow the installation instructions to install.
RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, activate all the safety devices provid-
ed and decide whether staff at work and those in the vicinity should be informed. In-
particular, turn off the water supply tap, cut off the electricity supply using the master-
switch and prevent access to all devices that might cause unexpected health and safe-
ty hazards if turned on.
If worn parts have to be replaced, use original spare parts only.
The manufacturer declines all responsibly for injury or damage to components due
tothe use of non original parts, or extraordinary work on the appliance which may mod-
ifythe safety requirements without the manufacturer's authorisation.
When ordering components, follow the instructions provided in the parts catalogue.
DECOMMISSIONING THE APPLIANCE
When decommissioning the appliance, a series of procedures must be carried out
toensure that the appliance and its components are not a hindrance and are not eas-
ilyaccessible.
To ensure that the appliance cannot constitute hazards for people or the environ-
ment,all energy sources (electricity, etc.) must be disconnected and rendered unusa-
ble, andany liquids present must be drained (lubricants, fluids, etc.).
Place the appliance in a suitable area which is not easily accessible, with barriers to-
IT
prevent anyone from accessing it.
When scrapping, sort all components by chemical characteristics and dispose of
US
themseparately in accordance with the relevant legal requirements.
Important
DE
This operation must be carried out by skilled operatives in compliance with thel-
egal requirements with regard to safety at work. Never dump non-biodegrada-
CAN
ble materials, lubricating oils and non-metallic components (rubber, PVC, res-
ins, etc.) in the environment. Dispose of them in accordance with the relevantle-
ES
gal requirements.
LIST OR RULES
The blast chiller we manufacture complies with the following rules:
UL listed for electrical safety - UL471, CSA C22.2.120, NSF standard 7 for sanitation.
English
REPLACING PARTS
- 54 -
8
Use and installation manual