Controlling Somfy Rts Wireless Equipment; Programming The Monitor On A Somfy Rts Unit - SOMFY V100 Notice D'installation Et D'utilisation

EN

7. CONTROLLING SOMFY RTS WIRELESS EQUIPMENT

7.1 Programming the monitor on a Somfy RTS unit

The monitor is equipped with a Somfy Radio Technology (RTS) transmitter. It is only compatible with devices equipped with Somfy Radio Technology (RTS).
It is used to control the following Somfy equipment, individually or simultaneously:
• garage door motorisation,
• lighting receiver,
• roller blind motorisation,
• gate motorisation.
This functionality is possible thanks to a system of radio channels, identified by indicator lights.
Each channel corresponds to an individual remote control and can be used to control one or more devices. There is no limit to the number of pieces of equipment that
can be controlled by a single channel. The channel selection button is used to navigate between channels (mark 8, page 4).
Selecting the chosen channel to wirelessly control a piece of equipment
Press the channel selection button: the indicator light for the selected channel will flash.
Press the channel selection button as many times as necessary until the indicator lights show the required
channel.
Note: All the indicator lights comes on to indicate the 5th channel.
Important: Check that the equipment to be controlled wirelessly is not too far away from the monitor.
7.1.1 Programming a Somfy RTS radio roller shutter motorisation
Note: The monitor can be disconnected from the power supply to carry out this operation.
[1]. Identify the original control of the roller shutter, i.e. the remote control or the control point which only controls this roller shutter.
Note: - If the original control is lost or broken, and it is the only one to control the roller shutter, contact one of our Somfy advisors.
- If another control operates the roller shutter, use that to follow the steps below.
[2]. Partially open the roller shutter using the original control.
[3]. Press the PROG button on the original control until the roller shutter makes an up and down movement (or a series of 3 beeps). The programming
function is activated for 2 minutes.
[4]. Select a free channel by pressing the channel selection button on the monitor.
[5]. Use a fine-tipped object to briefly press the PROG button at the back of the monitor (next to the battery housing, no. 19, page 4). The roller shutter will
make an up and down movement (or a series of 8 beeps).
Original RTS transmitter
3
4
Note: To clear the programming on the video entry phone on a Somfy roller shutter motorisation, repeat all the steps detailed above.
11
5
Video door phone V100
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.