Wilo Vardo WEEDLESS-F Notice De Montage Et De Mise En Service page 257

9.6.1 Instructions on using screw lock-
ing devices
9.6.2 Which repair work may be carried
out
9.6.3 Replacing the cover cap and pro-
peller blades
Installation and operating instructions Wilo-Vardo WEEDLESS-F
Maintenance and repair
WARNING
The propeller blade has sharp edges!
Sharp edges can form on the propeller blades. There is a risk of limbs being severed.
Wear safety gloves to protect against cuts.
WARNING
Hand, foot or eye injuries due to the absence of protective equipment!
Danger of (serious) injuries during work. Wear the following protective equipment:
• Safety gloves for protection against cuts
• Safety shoes
• Closed safety goggles
For repair work, the following applies:
▪ Wipe up drips immediately.
▪ Always replace O-rings, gaskets and screw locking devices.
▪ For torques, see "Appendix [} 262]".
▪ Never use inappropriate force when carrying out this work.
Preparatory tasks
‡
Work must be carried out by two persons.
‡
Mixer decommissioned. See "Decommissioning [} 250]".
‡
Mixer is removed. See "Dismantling [} 250]".
‡
Mixer is disinfected. See "Clean and disinfect [} 252]".
1. Required tools are to hand.
2. Set the mixer down on a clean, even work surface.
3. Secure the mixer against slipping.
4. Prepare hoisting gear with lifting gear.
5. Prepare scantlings in order to lie the mixer horizontally.
6. Only carry out authorised repairs.
▶ Begin repairs.
Screwed connections can be fitted with a screw locking device. Self-locking nuts are
used as screw locking devices. Always replace screw locking devices!
▪ Replacing the cover cap and propeller blades.
▪ Replacing the hub.
▪ Replacing the mixer shaft.
▪ Replacing the drive unit.
DANGER
Danger due to fluids hazardous to health during installation!
Ensure that the installation site is clean and disinfected during installation. If contact
with fluids that are hazardous to health is possible, observe the following points:
• Wear protective equipment:
⇒ Closed safety goggles
⇒ Mouth protection
⇒ Protective gloves
• Immediately wipe up drips.
• Observe the specifications provided by work regulations! The operator must
make sure that personnel have received and read work regulations!
en
257