Use In Fluids Hazardous To Health; Transport; Installing/Dismantling - Wilo Vardo WEEDLESS-F Notice De Montage Et De Mise En Service

2.6

Use in fluids hazardous to health

2.7

Transport

2.8

Installing/dismantling

Installation and operating instructions Wilo-Vardo WEEDLESS-F
Safety
There is a danger of bacterial infection when using the device in fluids hazardous to
health! Thoroughly clean and disinfect the device after dismantling and prior to further
use. The operator must ensure the following:
▪ The following protective equipment is provided and worn when cleaning the device:
– Closed safety goggles
– Breathing mask
– Protective gloves
▪ All persons are informed about the fluid, the associated danger and its correct handling!
▪ Risk of injury from impact or crushing. Wear the following protective equipment:
– Safety shoes
– Safety helmet
▪ Comply with laws and regulations on work safety and accident prevention in force at
the site of installation.
▪ Demarcate the working area.
▪ Keep unauthorised persons away from the working area.
▪ Use the securing mechanisms provided.
▪ Remove loose components from the product.
▪ Observe packaging regulations:
– Impact-resistant
– Water-resistant
– Ensure the product is properly fixed in place.
– Protect product against dust, oil and moisture.
▪ Use only legally specified and approved hoisting and lifting gear.
▪ Select the lifting gear based on the prevailing conditions (weather, attachment point,
load, etc.).
▪ Always attach the lifting gear to the attachment points (lifting eyes) and ensure they
are securely attached.
▪ The stability of the hoisting gear must be ensured during use.
▪ When using hoisting gear, a second person must be present to coordinate the proced-
ure if required (e.g. if the operator's field of vision is blocked).
▪ Keep away from the hoisting gear's swivel range when hoisting the product.
▪ Persons must not stand underneath suspended loads. Do not move suspended loads
over workplaces where people are present.
▪ Risk of injury from:
– Slipping
– Tripping
– Impact
– Crushing
– Falling
Wear the following protective equipment:
– Safety shoes
– Safety gloves for protection against cuts
– Safety helmet
– Safety harness
▪ Comply with laws and regulations on work safety and accident prevention in force at
the site of installation.
▪ Demarcate the working area.
▪ Keep the working area free of ice.
▪ Keep the working area free of any objects lying around.
▪ If the weather conditions mean it is no longer possible to work safely, stop work.
▪ Keep unauthorised persons away from the working area.
▪ Work must always be carried out by two persons.
▪ Avoid any painful or tiring body postures.
▪ When working at a height of more than 1 m (3 ft) above the ground, use scaffolding
with a safety harness.
▪ Cordon off the working area around the scaffolding.
▪ Disconnect the device from the mains and secure it against being switched on again
without authorisation.
▪ All rotating parts must be at a standstill.
▪ Clean and disinfect the product thoroughly.
▪ Make sure that there is no risk of explosion when carrying out any work with electrical
devices.
▪ Only use properly functioning hoisting gear.
▪ Keep away from the hoisting gear's swivel range when hoisting the product.
en
233