General Information; About These Instructions; Copyright; Subject To Change - Wilo Vardo WEEDLESS-F Notice De Montage Et De Mise En Service

en
1

General information

1.1

About these instructions

1.2

Copyright

1.3

Subject to change

1.4

Warranty

2

Safety

2.1 Identification of safety instruc-
tions
230
General information
These installation and operating instructions are an integral part of the product. Read
these instructions before commencing work and keep them in an accessible place at all
times. Strict adherence to these instructions is a requirement for intended use and cor-
rectly operating the product. All specifications and markings on the product must be
observed.
The language of the original operating instructions is German. All other languages of
these instructions are translations of the original operating instructions.
These installation and operating instructions have been copyrighted by the manufac-
turer. The contents, of whatever type, may not be reproduced or distributed, or used for
purposes of competition and shared with others.
The manufacturer reserves the right to make technical modifications to the product or
individual components. The illustrations used may differ from the original and are in-
tended as an example representation of the product.
The specifications in the current "General Terms and Conditions" apply with regard to
the warranty and the warranty period. Any deviations must be contractually agreed and
shall then be given priority.
Warranty claim
If the following points are satisfied, the manufacturer is obligated to rectify every qual-
itative or constructive flaw:
▪ The defects are reported in writing to the manufacturer within the warranty period.
▪ Application according to intended use.
▪ All monitoring devices are connected and were tested before commissioning.
Exclusion of liability
An exclusion of liability excludes all liability for personal injury, material damage or fi-
nancial losses. This exclusion applies as soon as one of the following applies:
▪ Inadequate configuration due to inadequate or incorrect instructions by the operator or
the client
▪ Non-compliance with installation and operating instructions
▪ Improper use
▪ Incorrect storage or transport
▪ Incorrect installation or dismantling
▪ Inadequate maintenance
▪ Unauthorised repairs
▪ Inadequate construction site
▪ Chemical, electrical or electro-chemical influences
▪ Wear
This chapter contains basic information for the individual phases of the life cycle. Fail-
ure to observe this information carries the following risks:
▪ Injury to persons from electrical, mechanical and bacteriological factors as well as elec-
tromagnetic fields
▪ Environmental damage from discharge of hazardous substances
▪ Property damage
▪ Failure of important functions of the product
Failure to observe the information contained herein will result in the loss of claims for
damages.
The instructions and safety instructions in the other chapters must also be ob-
served!
These installation and operating instructions set out safety instructions for preventing
personal injury and damage to property. These safety instructions are shown differ-
ently:
▪ Safety instructions relating to personal injury start with a signal word, are preceded by
a corresponding symbol and are shaded in grey.
WILO GVA GmbH 2019-02