Product Data - salmson LIFTSON M Série Instructions De Montage Et De Mise En Service

Modules de relevage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
1. GENERAL
1.1 Uses
The LIFTSON M and L is an automatic sewage lifting unit built to EN
12050-1 for sewage both free of and containing faeces for the
reflux-free drainage of drainage points in buildings and properties
below the reflux level.
Among other things, the following may not be discharged:
solids, fibrous materials, tar, sand, cement, ash, rough paper, rubble,
rubbish, waste from abattoirs, fats, oils and swimming pool water.
A fat collector is to be fitted in businesses which produce sewage
containing fat.

1.2 Product data

1.2.1 Rating plate
Sewage lifting unit
Series (M or L)
Number of pumps 1 : V
2 : 2V
Motor
2 pôles : 2
4 pôles : 4
DN : 80 mm
Motor power
(3~) Three-phase motor : T4
(1~) Single-phase motor : M
1.2.2 Connection and electrical data
1.2.2.1 LIFTSON M
LIFTSON M -V
Connection voltage (V)
1~230 ±10% 3~400 ±10% 1~230 ±10% 3~400 ±10%
Connection type
Switch box
plug (earth)
Connected load (kW)
1.6
Nominal current (A)
7.5
Mains frequency (Hz)
Type of operation
Mass: W/H/D (mm)
630 / 770 / 555
Gross volume (l)
Switching volume (l)
Max. operating (1/h)
Overall delivery head
max. (mCE)
max. permissible geodetic
delivery head (mCE)
max. permissible pressure
in discarge pipe (bar)
Flow rate max. (m3/h)
Protection category
Weight (kg)
Max. medium
temperature (°C)
Max. ambiant (°C)
temperature
Max. solid grain size (mm)
Discharge DN
Inlet DN
Aeration DN
Speed of rotation (rpm)
LIFTSON L - 2V - 2 08 / 5,3 T4
LIFTSON M -2V
Switch box Switch box Switch box
EEC plug plug (earth)
EEC plug
1.5
2 x 1.6
2 x 1.5
3
2 x 7.5
2 x 3
50
S 3 15%
830 / 770 / 555
90
130
30
40
30
60 (30 per motor)
See rating plate
5
1.5
See rating plate
IP 67 2 mCE, (switchgear IP44)
45
72
40 (short-term 60°C)
40
45
65, 80
40, 100, 150
70
1450
1.2.2.2 LIFTSON L
Connection voltage (V)
Connection type
Puissance nominale (kW)
Connected load (A)
Nominal current (Hz)
Mains frequency
Mass : W/H/D (mm)
Gross volume (l)
Switching volume (l)
Max. operating (1/h)
Overail delivery head
max. (mCE)
Max. permissible geodetic
delivery head (mCE)
Max. permissible pressure
in discharge pipe (bar)
Max. flow rate(m3/h)
Protection category
Weight (kg)
Max. medium
temperature (°C)
Max. ambient (°C)
temperature
Max. solid grain size (mm)
Discharge DN
Inlet DN
Aeration DN
Speed of rotation (rpm)
2. SAFETY
These instructions contain important information that must be
followed when installing and operating the pump. The installer and
the responsible operator must therefore read these operating
instructions before assembly and commissioning. They must always
be available at the place where the installation is used.
In addition to the general safety instructions laid down here in the
Safety section, the special safety instructions laid down in the
following sections are also to be observed.
2.1 Danger symbols used in these operating instructions
Safety precautions in these operating instructions which, if
not followed, could cause personal injury are indicated by
the symbol.
with the following symbol used to indicate electrical voltage.
The symbol below indicates that by ignoring the
relevant safety instructions, damage could be
ATTENTION !
caused to the pump or installation.
2.2 Staff training
All assembly, operation, maintenance and installation staff must
have the appropriate qualifications for such work.
2.3 Risks incurred by failure to comply with the safety precautions
Failure to comply with the safety precautions could result in personal
injury or damage to the pump or installation. Failure to comply with
the safety precautions could also invalidate any claim for damages.
In particular, failure to comply may lead to problems such as.
- the failure of important parts of the installation,
- injury resulting from electrical or mechanical factors,
21
LIFTSON L -V
LIFTSON L -2V
2,95
3,8
4,9
5,3
2,95 3,8
3~400 ±10%
Switch box with EEC plug
3,0
3,8
4,9
5,3
2x3,0 2x3,8 2x4,9 2x5,3
6,0
6,9
8,5
8,9
2x6,0 2x6,9 2x8,5 2x8,9
50
S 3 15%
630 / 770 / 630
830 / 755 / 630
90
30
30
60 (30 per motor)
See rating plate
9
13
16
19
9
13
3
See rating plate
IP 67 2 mCE, (switchgear IP44)
55
40 (short-term 60°C)
40
40
65, 80
40, 100, 150
70
2900
4,9
5,3
130
40
16
19
85

Publicité

Table des Matières
loading

Table des Matières