End Of Welding; Aborted Welding Process; Cooling Time; Downloading The Reports - Hürner HST 300 Manual USB 2.0 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
5.6

End of Welding

The welding process ends successfully if the actual welding time cor-
responds to the nominal welding time and the buzzer can be heard
twice.
5.7

Aborted Welding Process

The welding process has failed if a plain-text error is displayed on the
screen and the audible signal buzzes continuously. An error has to be
acknowledged by pressing the STOP/RESET key.
5.8

Cooling Time

The cooling time as given in the fitting manufacturer's instructions has
to be respected. Note that for that time the pipe fitting joint which is
still warm must not be subjected to an external force.
6

Downloading the Reports

Interface
USB A Interface Port
for connecting USB mass storage media (such as a memory
stick)
The interface port complies with the USB version 2.0 specification (i.e.,
maximum data rate of 480 megabits per second).
Before transferring data, it is highly recommended to switch
the welding unit off and on again. If this fails to happens,
there is a risk of data transfer failure, or reports in the weld-
Important
ing unit may be corrupted.
When transferring welding reports to a USB stick, always
be sure to wait until the display shows the "Download fin-
ished" message before you disconnect the USB stick from
Important
the product. If you disconnect it too early, the unit may ask
you whether you want to delete the reports in memory, al-
though they were not properly transferred. In this case, if
you delete the contents of the report memory, the welding
reports would be irrevocably lost and would not be available
elsewhere either.
6.1

Selecting the File Format

Connecting the storage media causes the the screen to appear in which
the format of the output file with the welding reports can be selected:
a PDF file with an abstracted or extended version of the report or the
format of the welding data management application DataWork. Using
the ñ and ò arrow keys, select the file type you need and confirm
your selection by pressing the START/SET key.
The Service Report option is not important for normal operation. In
the scope of computer-assisted unit service, this report lists the events
related to the maintenance of the welding unit.
6.2

Downloading All Reports

After the file type was selected, the next screen offers a "Print All Re-
ports" option. Selecting it will download all welding reports currently
Version February 2014 HÜRNER HST 300 Manual USB 2.0 User's Manual
* Select File Type *
DataWork File
>PDF Abstract
PDF Ext'd Report
Display 4
EN
9