Siemens SINUMERIK 840D sl Manuel De Mise En Service page 498

Mise en service HMI Advanced (IM4)
2 Fonctions / paramétrage
CommitLatency = -1
DirectoryPath = D:\AC_LOG
FileSize = 40000
Variable0 = 1, /Channel/ProgramInfo/msg
CommittedAlarms = 3000
;[NCDDE_STARTCMD]
CMD=dpncsim.exe /T:1 /P:0
WND_CLASS=SIM_LOCAL_NCK
WND_NAME=SIM_LOCAL_NCK
STARTUP_TIMEOUT=50
;WAIT_SYNC_MESSAGE=
CLOSE_TIMEOUT=30
[WP_SELECT]
TOA_WARNING_MESSAGE=yes
[PCU]
UsbFront=G: ' access rights of the PCU USB device (0-7) for the application
machine, program and services
AccessMachine=7
AccessProgram=7
AccessServices=7
[PROGRAM]
IgnoreMissingProgramAndChan=0
IM4/2-102
; DirectoryPath specifies the directory of the logfiles
; FileSize gives the upper limit of logfile size in bytes
; VariableN allows monitoring of max 10 NC/PLC variables. The first
; parameter is numericand provides the monitoring mode:
; if Bit0 is set and the value of the variable changes, the value changes
; are protocolled in the ActionLog files
; if Bit1 is set and the value of the variable changes, the ActionLog files
; are commited to disk
; Default : Variable0 = 1, /Channel/ProgramInfo/msg
; monitor part program messages
; CommittedAlarms holds up to 10 comma separated alarm numbers.
; Changes of these alarms commit
; ActionLog data to disk
; Default : CommittedAlarms = 3000
; commit on emergency stop
; for working with SIMNC uncomment the following section descriptor
; by this way a sim-process will be started to be used as a machine
; for displaying a message that TOA/TMA-data on NCK will be overwritten
;TOA_WARNING_MESSAGE = yes/no
; device name of PCU for USB local
;0=message to user if a program of the DAT-file for MCSE was not
; found or a channel doesn't exist (default)
;1=skip all entries of DAT-file if the program or a channel was not found
SINUMERIK 840D sl/840D/840Di/810D MES HMI (IAM) - Edition 08/2005
© Siemens AG 2005 All Rights Reserved
08/2005