Dh.ini; Dpdh.ini; Dpsim.ini - Siemens SINUMERIK 840D sl Manuel De Mise En Service

08/2005

2.5.6 DH.INI

Exemple :
[ACCESSMASKS]
\wks.dir\*.wpd\*.mpf =
\mpf.dir\*.mpf =
\cus.dir\*.spf =

2.5.7 DPDH.INI

[ACCESSLEVEL]
PROGRAMMEUR=4
OPERATEUR=5
ENABLE_DIALPROG=0
SetStandardWpSave=2
ENABLE_SIMULATION=7

2.5.8 DPSIM.INI

[ACCESSLEVEL]
SETUP=1
UTILISATEUR=3
OPERATEUR=5
[MAIN]
EXTERN_MODAL=0
EXTERN_SIZE=150000
EXTERN_CHECK=1
SIM_LOAD_TOOLS=1
© Siemens AG 2005 All Rights Reserved
SINUMERIK 840D sl/840D/840Di/810D MES HMI (IAM) - Edition 08/2005
75775
75775
33773
;minimum level for changing setup standard:
;<>0: simulate program extern modal (see also
; EXTERN_SIZE,EXTERN_CHECK)
; simulate program extern modal, if program
; size >= EXTERN_SIZE
; only if EXTERN_MODAL<>0
; only if EXTERN_MODAL<>0
; <>0: reset tool data, if new workpiece is selected
; =0: use current tool data, if new workpiece is selected
Mise en service HMI Advanced (IM4)
2 Fonctions / paramétrage
IM4/2-85