Servo; Timer - Multiplex PROFI TX 16 MasterEdition Mode D'emploi

4. Control functions ( controller options )
Menu point: "Control functions\curve"
Important: First, assign the "Curve" functionality in "Setup\
Controller" under "Name+Function" e.g. "Flap".
The control signal is now guided through a 9-point curve.
Menu point: "Control function\mixture"
Important: First, assign the "Mixture" functionality in "Setup\
Controller" under "Name+Function" "Mixture".
The untrimmed "throttle" control signal is now guided through
a 9-point curve.
Menu point: "Control function\motor sequencer"
Important: First allocate the name "Mechanism aps" to a free
functionality e.g. "Free-3" in "Setup\assign controller" under
"Name+Function" and assign the "Motor sequencer" func-
tionality.
The menu is separated into the areas of "Extend" and "Re-
tract". Both are set up identically, although "Extend" contains a
second delay when closing the aps until releasing the motor
control. Retraction is extended with a second "motor coasting"
delay to allow the motor to cost before opening the aps.

5. Servo

Assignment
· Curves can be selected via points 2-3-5-9. Intermediate
values are calculated automatically during "upshifting"
· The 7 copilot channels can be freely assigned on the servo
side and engaged with curves.

6. Timer

Timer1, .\Timer2, .\Timer3
· The current timer value can be announced at any time using
a freely assignable switch.
· The timer value which was current when the switch was
changed is announced. Until the actual time is announced,
the time may be several seconds later.
16
· Switching point: If the assigned controller exceeds/falls short
of this value, the mechanism extends/retracts.
· Delay of 0 to 12sec adjustable
· Duration: Following the delay, the mechanism extends/re-
tracts over the set time (up to 12sec).
· Motor coasting: Delay of 0 to 12sec adjustable
The sequence may be as follows:
"Extend" sequence: "Retract" sequence:
a. Controller set to OFF
a. Controller set to ON
b. Open aps b. Delay (motor coasting)
c. Open aps
c. Delay
d. Delay
d. Extend mechanism
e. Delay e. Retract mechanism
f. Delay
f. Close aps
g. Close aps
g. Delay
h. Release motor
· The 4 trim controls of the basic control functions can be
issued as individual servo signals.
Alignment
· The menu is now dynamic: Only the input elds of the active
curve points are displayed.