Multiplex PROFI TX 16 MasterEdition Mode D'emploi page 14

3. Menu setup
Assign Controllers\Name+Functionality
The name and functionality of the control functions can be
modi ed here. Aileron, elevator, rudder and throttle have xed
--- The control function has no adjustments.
Only slow Only slow, as previously with the throttle limiter.
Slow+ xed value Slow and phase-dependent xed values, as previously with Slow, Flap, etc.
Undercarriage sequencer For retractable undercarriages. Can be linked with one or several ap sequencers.
Flap sequencer Can be forcibly controlled using undercarriage or motor sequencer.
Multi position 2 to 9 adjustable xed servo positions can be selected with the assigned controller and an addi-
tional optional switch.
Curve 9P-curve as with Pitch. Own set of parameters: A curve from the mixer curve set is used.
Gyro As known. The "Gyro" functionality is linked with REAR ROTOR and the 3 main control functions.
It may only be used once at the moment with heading gyros!
Mixture Concept: The untrimmed throttle signal is guided over a 9P-curve.
Application: Mixture control of burners, control of smoke generators.
Motor sequencer Application: Flap mechanism. Like undercarriage sequencer, extended with functionalities for
motor control.
Assign Switches
The sub menu "Switch point" can be found in the "Setup\As-
sign switch" menu. Here, switching thresholds can be set for
all 4 joystick axes. The new switches were added to the back
of the switch list due to downward compatibility. This means
they cannot be assigned using Quick select. The switch points
lie symmetrically to the neutral position. On and off switch
points can be adjusted separately.
CAUTION! The switching thresholds can be selected manually
and also set directly, if for instance the respective joystick
moves into the corresponding position and then the REV/CLR
button is pressed.
The new, virtual joystick switches can only be assigned to the
switch functions in this menu. The volume can only be con-
trolled with the PROFI TX 16.
14
functions. One of the following functionalities can be selected
for the remaining control functions:
In the "Toggle function" sub menu, a toggle functionality can
be activated for each of the 16 possible, mechanical switches.
After switching on or switching memories, the switch state is
initially "OFF". If toggle is to start with "ON", the switch must
be reverse assigned.
MagicSwitch, MS2 to MS4
It is now possible to perform AND links to sensor values. The
following are set: sensor address, ON threshold, OFF thresh-
old. Default de nes the switch state if the reassignment should
fail.
If the switch function "Announce time" is assigned to a
switch, the current time can be requested (announced).