Servo Reverse; Switching The Special Function For Tamiya Model Trucks And Tanks On And Off - Multiplex SMART SX FLEXX Notice D'utilisation

3.5
3.6
Page 58

The status LED on the receiver flashes slowly in yellow.
The binding information is permanently stored in the receiver, so that re-binding is
not required at the next start.
If an ID receiver is used, an acoustic signal is emitted after binding and the
transmitter automatically loads the corresponding settings. Therefore, it is not
necessary to reconfigure the settings for servo reverse and trimming every time.

Servo reverse

The direction of movement of the servo can be reversed for the following servo
channels.
Please note: Directly after the transmitter is switched on, the multi-function button is
busy with the activation of the range mode for approx. 5 seconds. After switch-on,
please wait for 5 seconds before using servo reverse.
Channel 1 to 4 (proportional actuator)
1. Move the desired function to an end position, e.g. steering fully to the left or
fully to the right.
2. Press and hold the multi-function button for approx. 3 seconds.
3. The servo reverse is confirmed by an acoustic signal.
Channel 5, 6 and 9 (2- and 3-position switch)
1. Press and hold the rocker switch.
2. Press and hold the multi-function button for approx. 3 seconds.
3. The servo reverse is confirmed by an acoustic signal.
Channel 7 and 8 (stick buttons)
1. Press and hold the stick button.
2. Press and hold the multi-function button for approx. 3 seconds.
3. The servo reverse is confirmed by an acoustic signal.
Switching the special function for Tamiya model trucks and
tanks on and off
The special function for Tamiya model trucks and tanks can be switched on and
off.
Transmitter
SMART SX FLEXX