2.3. Correct use
The RECARO Pro Racer SPG XL HANS and
RECARO Pro Racer SPA XL HANS racing shells
may only be used in motor sports in conjunction
with the independently tested RECARO adapt
ers 7207450A (SPG XL HANS), 7207000A (SPA
XL HANS) or 7206293.
There is no 'ABE' general operating permit
(necessary for operation on public roads in Ger
many) for the racing shells RECARO Pro Racer
SPG XL HANS and RECARO Pro Racer SPA XL
HANS, or for the RECARO adapters 7207450A,
7207000A and 7206293. These racing shells
and adapters are not approved for use on public
roads under the German road traffic licensing
regulations (StVZO), the basis for regulating
road traffic law in Germany.
Racing shell and adapter are designed solely for
use in motor sports.
The RECARO Pro Racer SPG XL HANS and
RECARO Pro Racer SPA XL HANS racing shells
must not be used after the date shown on the
homologation sticker
(Not valid after: xxxx).
After this date the racing shells may never again
be used in a vehicle.
RECARO racing shells that have been subjected
to the stresses of an accident (racing accident or
collision) must no longer be used.
2.4. Staff qualification
Only authorised experts may install and remove
racing shells. This also applies to the prior removal
of standard seats that are fitted with a side airbag in
the seat and/or pyrotechnic belt tensioners.
2.5. Installation instructions
Securing of the racing shell and the adapter in the
vehicle and the related structural modifications to
the vehicle must be done in accordance with the
specifications of the relevant national ASN (Autorité
Sportive Nationale) or the FIA (Fédération Interna
tionale de l'automobile) as per the respective appli
cable version of the regulations that apply.
2.6. Structural alterations
Structural alterations and the use of unapproved
components can jeopardise safety and functional
capability.
When installing the RECARO racing shell, use
only original components from RECARO.
Do not modify the racing shell, or its homologa
tion will be rendered void.
Do not fit any additional parts (such as bever
age holders, fire extinguishers etc.) to the racing
shell.
2.7. Residual risks
The supplied microencapsulated screws can break
or come loose if they are reused several times.
In some circumstances, this can cause the racing
shell to become detached from its anchoring in the
event of an accident, and thus present a danger to
life and physical condition.
Use only the supplied microencapsulated
screws when installing the racing shell.
Use the supplied microencapsulated screws
only once.
Tighten all screws with the specified torque.
11