D-2. Serial Interface - Star SP2000 Série Mode D'emploi

D-2. Serial Interface

Be sure to turn the power to both the printer and host computer off before
changing the setting of the DIP switches.
Power off
ON
8
1
OFF
DIP switch 2
ON
1 8
OFF
DIP switch 1
Fig. D-2 DIP switch array
The following is the procedure for changing the settings on DIP switch No. 2.
1. Turn the power to both the printer and computer off.
2. Remove the 2 screws.
3. Remove the serial interface board unit.
4. Change the setting of the DIP switches.
DIP switch 2
Fig. D-3 DIP switch 2
– 138 –