Star SP2000 Série Mode D'emploi page 140

Switch 1-1 Switch 1-2
ON ON
ON OFF
OFF ON
OFF OFF
*1 The factory settings for enabling/disabling the auto-cutter are as follows.
Models without auto-cutter (SP2300 Series): Invalid (Switch 1-4 = on)
Models with auto-cutter (SP2500 Series): Valid (Switch 1-4 = off)
Note: If the auto-cutter is valid on models without this function, a mechanical
error will occur. Do not enable.
*2 Total dot number for one line.
(This setting determines the default print range and number of digits as
follows.)
Switch 1-5 Print range
ON
OFF
*3 Automatic status function
When valid, the status occurrence conditions are as follows.
Star mode:
ESC/POS mode: Online/offline factors only. (Same conditions as <GS>a 2).
*4 Disable if using #36 pin (nSelectIn/1284 Active) interface for functions other
than IEEE1284.
Reset input conditions
#31 pin (nInit) "Low" input
#31 pin (nInit) "Low" input and #36 pin
(nSelectIn/1284 active) "Low" input
Reset input disabled
#31 pin (nInit) "Low" input
63 mm
60 mm
All status occurrences enabled.
– 137 –
Enable/disable
IEEE1284 reverse mode
Enable
Enable
Enable
Disable *4
ANK default digits (ANK 7 × 9/5 × 9)
42/35 digits
40/33 digits