Appendix D: Dip Switch Setting; D-1. Parallel Interface - Star SP2000 Série Mode D'emploi

D-1. Parallel Interface

Be sure to turn the power to both the printer and host computer off before
changing the setting of the DIP switches.
Power off
1
ON
OFF
DIP switch 1
DIP switch 1
SW
1-1 Reset input conditions or enable/disable
1-2 conditions IEEE1284 reverse mode
1-3 Always ON
1-4 Auto Cutter *1
1-5 Printing width *2
1-6 Automatic status function *3
1-7 Should not be change
1-8 Command emulation

Appendix D: DIP Switch Setting

8
Fig. D-1 DIP switch array
Function
– 136 –
Factory presetting: All on
ON
See table below
Should be set on
Invalid
210 dots
(420 half dots) (400 half dots)
Invalid
(Should be set on)
Star
*1
OFF
Valid
200 dots
Valid
ESC/POS