Connecting The Interface Cable; Rs-232C Or Rs-422A Serial Interface; Centronics-Type Parallel Interface - Star TSP400 Guide D'installation

4. CONNECTING THE INTERFACE CABLE

4-1. RS-232C or RS-422A Serial interface

Follow the procedures below to connect the interface cable:
Interface cable
Fig. 4-1
NOTE: The data transfer conditions between the computer and the printer must
be made compatible with the DIP switch settings on the printer. (Refer
to "APPENDIX".)

4-2. Centronics-type Parallel interface

Fig. 4-2
Interface connector
1 Switch off the power to the printer
and computer.
2 Insert the interface cable into the
connector. (Be sure that the cable is
oriented correctly before inserting
it.)
3 Fasten the right and left screws to
fix them in place on the connector.
4 Connect the other end of the inter-
face cable to your computer.
1 Switch off the power to the printer
and computer.
2 Insert the interface cable into the
connector. (Be sure that the cable is
oriented correctly before inserting
it.)
3 Fasten the connector clasps.
4 Connect the other end of the inter-
face cable to your computer.
– 5 –