Star SP2000 Série Mode D'emploi page 21

[When using single-ply paper]
Paper feeder
Fig. 6-14 Loading the paper
[When using multi-ply paper]
Upper
paper
Print head
Fig. 6-15 Insertion of the paper into the auto cutter
Auto cutter paper
slit
Roll paper
Lower paper
(When using copying paper)
– 18 –
5 Inset the edge of the paper into the
paper feeder. If inserted correctly,
the edge of the paper will pass
through the auto cutter paper slit.
The paper will be cut once.
6 Remove the cut tip, and mount the
cover by reversing the procedure
outlined in step 1.
Note: When the paper end mark
appears on the paper, replace
the paper roll before it runs
out.
Paper
insertion
slit
Platen
Platen
Print head
5 Lift up the auto cutter and place it in
a vertical position.
6 Insert the edge of the paper into the
paper feeder. If inserted correctly,
the edge of the paper will pass
through the paper exit.
Auto cutter
Upper paper
Lower paper