Star SP2000 Série Mode D'emploi page 142

DIP switch 1
SW
1-1 Not used
1-2 Hand shaking (BUSY condition)
1-3 Always ON
1-4 Auto Cutter *1
1-5 Printing width *2
1-6 Automatic status function *3
1-7 Should not be change
1-8 Command emulation
*1 The factory settings for enabling/disabling the auto-cutter are as follows.
Models without auto-cutter (SP2300 Series): Invalid (Switch 1-4 = on)
Models with auto-cutter (SP2500 Series): Valid (Switch 1-4 = off)
Note: If the auto-cutter is valid on models without this function, a mechanical
error will occur. Do not enable.
*2 Total dot number for one line.
(This setting determines the default print range and number of digits as
follows.)
Switch 1-5 Print range
ON
OFF
*3 Automatic status function: When valid, the status occurrence conditions are
as follows.
Star mode:
ESC/POS mode: Online/offline factors only. (Same conditions as <GS>a2).
Function
63 mm
60 mm
All status occurrences enabled.
– 139 –
Factory presetting: All ON
ON
(Always ON)
Receive buffer
full or offline
Should be set on
Invalid
210 dots
(420 half dots)
Invalid
(Should be set on)
Star
ANK default digits (ANK 7 × 9/5 × 9)
42/35 digits
40/33 digits
*1
OFF
Recive
buffer full
Valid
200 dots
(400 half dots)
Valid
ESC/POS