Star SP2000 Série Mode D'emploi page 34

...
Level 3
......
Level 2
.........
Level 1
Fig. 8-2
ø18 mm
ø12 mm
Roll paper core
Fig. 8-3
4 Determine the diameter of the roll
paper you are using and find the
required setting in the table below.
Distance A
Approximate 9 mm
Approximate 7 mm
Approximate 5 mm
*1 Cannot be used with 2 and 3 ply.
Note:
1. Since the distance A correspond-
ing to the adjustment position on
the chart is a calculated value,
there may variations due to the
actual mechanism.
2. If there is an end mark at the end
of a roll of paper, that end mark
is an adhesive that may lift the
entire roll of paper. In such a
case, the remaining roll paper
amount (Distance A) shown in
the chart above will not apply.
3. The quality of some paper may
cause it to become jammed. This
can result in erroneous detec-
tion.
5 Insert the tip of a ballpoint pen or
similar pointer object into the hole
of the adjuster. While pressing the
adjuster, slide it up or down to the
setting you that matches the roll
A
paper you are using.
6 Make sure the tab indicated by the
arrow in the illustration is inside
one of the grooves.
– 31 –
Setting Indicator
Level 3 ooo
Level 2 oo
*1
Level 1 o