Connection Configurations - Agilent Technologies TV 551 Notice De Mode D'emploi

WARNING! It is mandatory to connect the pump in such a way to withstand the torque
specified in the "INSTRUCTION FOR USE" section. Specifically pay attention
to clamp design, material of clamps and bolts and bolt fixing torque.
To facilitate assembly and dismantling, apply Fel-pro C-100 high
temperature lubricant to the screw threads protruding from the
flange and between the nuts and flange.
Note that the connections can be made only with the bolt in the lower
side.
Attach the units and tighten each one in turn. Repeat the sequential
tightening until the flange faces meet.
Exercise care when tightening nuts and bolts to avoid creating dents in the
CAUTION!
envelope as this may cause the pump rotor to lock.

Connection Configurations

Figure 53
TV 551/701 SEM Navigator User Manual / 87-900-958-01(G)
Technical Information
TV 551/701 SEM Controller Installation
17
263/276