Getting Started - Steba PS E2600 XL Mode D'emploi

Getting started

Important:
The appliance can smoke slightly when used the first time. Never put oversized food
inside the oven and prevent any contact to the heating elements. Food which con-
tains much fat should be grilled on level 3, the drip tray should be put 2 levels below.
∙ Connect the device to the mains and push the ON/OFF switch on the rear.
∙ Insert the grill plate and drip tray with the tray handle into the device and remove
the handle.
∙ Press the button. The display shows the current temperature within the hea-
ting elements and 10 minutes.
∙ If no setting is made within 20 seconds, the device turns into stand-by mode.
∙ Press the button, the temperature display flashes.
∙ Use the +/- buttons to change the temperature from 400°C to 850°C in steps of
10°C.
∙ Press the button again, the timer display flashes.
∙ Use the +/- buttons to change the time from 10 minutes to 99,59 minutes in steps
of 30 seconds.
∙ Pres the button to start the device.
∙ As soon as the device heats up, an LED lights up next to the temperature display.
Once the desired temperature has been reached, a short signal sounds and the set
time starts to run.
∙ Attention: use oven gloves while working with the device!
∙ During operation, the temperature and time can be changed at any time. Press the
button, the temperature display flashes. Now this can be changed with the
+/- buttons. By pressing again, the temperature is confirmed and the time can be
set. Press the
18
button to start the device with the newly set values.