Emptying The Dust Container - Cleanmaxx LD-622 Mode D'emploi

The fi lters may lose some of their colour over time. This is normal and does not
have any adverse effect on function.

Emptying the Dust Container

1. Press the release button of the dust container and pull it out of the device by the
handle.
2. Hold the dust container over a dustbin.
3. Press the button to open the dust container. The bottom of the dust container will
open and the dirt will fall out.
4. Flip the bottom of the dust container shut again. The catch must be heard to engage
in place.
Inserting the Dust Container into the Device
1. Grip the dust container by the handle and fi rst insert the bottom of the container into
the device.
2. Press the handle against the device housing until the dust container audibly engages
in the locking catch.
3. Lift up the device by the dust container handle to check whether the dust container
is in the correct position.
Cleaning the Cyclone Insert and Motor Filters
The cyclone insert is located in the dust container. The motor fi lters are seated in the fi lter
holder on the cyclone insert.
1. Remove the dust container from the device and empty it (see "Emptying the Dust
Container").
6. Remove the cyclone insert from the dust container.
7. Clean the dust container and cyclone insert with a damp cloth and then dry them
thoroughly.
8. Insert the cyclone insert into the dust container. Make sure that the arrow on the cy-
clone insert points towards the suction opening on the dust container.
9. Insert the foam fi lter into the fi lter holder.
10. Place the fi lter holder onto the cyclone insert with the foam fi lter facing downwards.
11. Place the lid on the dust container so that the right marker on the lid points towards
the symbol on the dust container. Twist the lid clockwise to shut it. The left mark-
er on the lid points towards the
12. Insert the dust container into the device (see "Inserting the Dust Container into the
Device").
21
2. Twist the lid of the dust container a little anticlockwise and
C take it off.
3. Remove the fi lter holder (C) with foam fi lter.
4. Remove the foam fi lter.
B
Please Note: The second motor fi lter is fi rmly attached
to the fi lter holder and cannot be taken out of the holder!
5. Tap out all parts and brush off any loose dirt.
IMPORTANT: Do not clean the motor fi lters with water!
symbol.
EN