Cleaning And Storing; Emptying The Dust Container - Cleanmaxx T-110-80 Mode D'emploi

Cleaning and storing

CAUTION!
❐ Empty the dust container if it is full and clean the HEPA fi lter regularly to prevent
overheating of the motor.
❐ Always remove the mains plug from the plug socket before doing any cleaning of
the device.
❐ Keep the device, the cable and the mains plug away from water or other liquids in
order to avoid electric shocks. Make sure that no liquid gets into the device during
cleaning. Only the HEPA fi lter and the dust fi lter may be cleaned with water. Howe-
ver, they must be completely dry before they are put back into the device.
❐ The HEPA fi lter is not machine-washable, dishwasher-safe or suitable for tumble
drying! Only ever dry the fi lter in the air, and never use a hair dryer to do so.
❐ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the
device. These could damage the surfaces.
• Clean the HEPA fi lter regularly or if you notice a decrease in the suction power.
• Clean the housing if necessary using a damp, soft cloth. Dry it with a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.
• Store the vacuum cleaner and the nozzles in a cool, dry indoor room out of the reach
of children and animals.
The HEPA fi lter may lose some of its colour over time. This is normal and does
not have any adverse effect on function.

Emptying the Dust Container

1. Hold the device over an open dustbin.
2. Press the release button to open the dust container. The
bottom of the dust container will open and the dirt will fall
out.
3. Then fl ip the dust container fl ap closed again. The fastener
must be heard to engage in place.
4. If necessary, you can rinse the dust container with clear,
lukewarm water. To do this, remove the dust container
from the device (see the „Cleaning the HEPA Filter"
chapter).
21