Yamaha Motor WARRIOR Manuel Du Propriétaire page 260

1. Oil filter cover
3. O-ring
1. Couvercle du filtre à huile
3. Joint torique
1. Tapa del filtro de aceite
3. Junta tórica
2. Oil filter
2. Filtre à huile
2. Filtro de aceite
5. Remove the oil filter cover and oil filter.
6. Clean the oil strainer and oil filter with sol-
vent.
7. Check the O-ring for damage and replace
it if necessary.
8. Install the oil filter, O-ring, oil filter cover,
oil strainer, compression spring and drain
bolt. Tighten the drain bolt to the specified
torque.
CAUTION:
Before installing the drain bolt, be sure to in-
stall the O-ring, compression spring and oil
strainer.
Tightening torque:
Drain bolt (engine):
32 Nm (3.2 m·kg)
Filter cover bolt:
10 Nm (1.0 m·kg)
9. Fill the engine with oil, and then install the
dipstick.
8-19