Model Utilities (Continued); Delete Model - Spektrum DX5 Rugged Manuel D'utilisation

EN
UTILITIES

MODEL UTILITIES (CONTINUED)

Create New Model
1. Select the CREATE NEW MODEL and click the scroll wheel.
2. Select CREATE to create a new model or CANCEL to go back.
3. The new model is available in the model select list.
CAUTION: NEVER change the model in Model Select while operating a model. Changing the model
memory interrupts the transmitter signal to the receiver and may cause loss of vehicle control, damage
or personal injury.

Delete Model

Use this selection to permanently delete a model from the model select list. If you do not wish to delete a
model, select Cancel to exit the page.
1. To delete a model, highlight the model listed. Press OK, then slide to the model name. Press OK to select
the model.
2. Select DELETE to delete the model.
Model copy
The Model Copy menu enables you to duplicate model programming from one Model List location to another.
Use Model Copy to:
• Save a default model copy before experimenting with programming values
• Expedite programming for a model using a similar programming setup
IMPORTANT: Copying a model program from one model memory to another will erase any programming in
the "To" model memory.
To copy model programming:
1. Select where to save the copied memory by selecting "TO" and scroll to ADD NEW MODEL. Press OK to
save the selection. To save over a current model, select that model from the list.
2. Select the model to be copied by selecting "From" and slide to the model to be copied.
3. Slide down to COPY at the bottom of the screen and press OK.
4. Confi rm the copy by selecting COPY or CANCEL to go back.
Reset Model
Use the Model Reset menu to delete all model programming in the active model memory. Reset returns all
model settings to the default settings and erases all programming in the selected model.
IMPORTANT: After a model reset, it is necessary to re-bind.
Sort Model List
With this function you can sort the model order in the model select function. This is helpful to group similar
models together to make them easy to fi nd. To move a model, highlight the model that you wish to move
with the slide button, then press OK to select it. Use the slide button to move the selected model to the
position desired. Press OK when you have the model in the position desired.
16
SPEKTRUM DX5 RUGGED • TRANSMITTER INSTRUCTION MANUAL