Konica Minolta MULTI GLOSS 268 Mode D'emploi page 34

Save 12
Select memory
All available areas of memory are
listed in this menu, beginning with
the one that is predefined.
The number of measurements
saved for each area in memory is
shown on the right.
Select the appropriate memory
area with the scroll wheel and
activate the selection by pressing
mode.
This automatically turns on Save
and switches the geometry if
necessary (if the selected memory
area is defined for other geometries
than what was previously set).
Create memory
Users can set up their own memory
areas with this function. Select the
required geometry before you
activate this function. Then you
must enter the name of a memory
area. You can confirm the
suggested name directly with the
operate button or change it with the
scroll wheel. After you confirm,
Save is automatically turned on.
33