Setup; Meanings Of The Various Parameters - SOMFY Dexxo Pro io Manuel D'installation

Dexxo Pro io
> Remote lighting (Fig. 38)
Class 2 (double insulation) light units that are connected do not require an earth
connection.
Various types of lighting can be connected without exceeding a total power
consumption of 500 W.

7 - SETUP

7.1 Meanings of the various parameters

(Boldface text = default values)
Operating mode
Values 0 : sequential
Comments Automatic closure mode operation is only possible if
In automatic closure mode, the door is automatically closed
after the end of the time delay set with setting "t0
Orange warning light
Values 0: without advance warning
Comments If the garage opens onto a public road, always select with
Safety input
Values 0: no safety mechanism
Comments If value 0 is selected, the safety input is not taken into
account.
If value 1 is selected, the system's self test is run at the start
of every operating cycle.
If value 2 is selected, the safety system runs without a self
months.
Obstacle detection
sensitivity
Values
2: standard
obstacle detection complies with annex A of the standard EN 12 453.
Non-observance of this instruction can result in serious injury to
persons, e.g. when trapped by a door.
Partial opening cycle
Values 0 : not valid
Comments
Pressing the button programmed for partial opening causes
partial opening; pressing the button programmed for full
opening causes full opening.
When this parameter is activated, pressing a
previously programmed remote control button will
partially open the garage door; an additional command
must then be performed so that the button fully opens
the gate again (refer to "Programming Keygo io remote
controls for full and partial opening operation")..
WARNING
Closing speed
Values
to
By default, 6: approx. 12 cm/s
Comments If spurious detection of obstacles occurs when this
programming will have to be carried out again.
obstacle detection complies with annex A of the standard EN 12 453.
Non-observance of this instruction can result in serious injury to
persons, e.g. when trapped by a door.
Partially open position
Values Storing the position as illustrated in Fig. 40.
Closure approach speed
Values
1: short soft stop
Comments
If spurious detection of obstacles occurs when this
programming will have to be carried out again.
obstacle detection complies with annex A of the standard EN 12 453.
Non-observance of this instruction can result in serious injury to
persons, e.g. when trapped by a door.
Opening speed
Values
to
9: fastest speed: approx. 18 cm/s
Comments If spurious detection of obstacles occurs when this
programming will have to be carried out again.
Choice of operating direction (type of door)
Values 0: direction 1: all types of doors except swinging doors
Comments
be repeated along with self-learning.
Safety action prior to opening (safety ADMAP)
Values 0: no effect
Comments If value 1 is selected, triggering the safety input will inhibit
door opening.
Safety action during closure
Values
3: fully reopen
Comments Value 1 is not allowed when using a sensor bar on the
safety input.
WARNING
WARNING
Copyright © 2015 Somfy SAS. All rights reserved