Extra Receiver; Frequently Asked Questions (Faqs) - Marmitek Audio Anywhere 625 Guide Utilisateur

4.3

Extra receiver

Extra receiver for your Audio Anywhere 625.
With an extra receiver you can receive the signal of the sender at
more places in your house.
5

Frequently asked questions (FAQs)

I can't connect my Audio Anywhere 625.
Check the following:
1. Ensure that the power adapter is connected and the power
LED (5) is on (red).
2. Ensure that the distance between the transmitter and
receiver is not greater than 10 metres and that there are no
large obstacles in the way.
3. Check that the connection LED (4) is on (not blinking). If it is
not on, press the ON/OFF switch (3).
No sound comes out of the audio installation.
Ensure that the audio cable is correctly connected (AUX IN),

that the correct input has been selected on your audio
installation and that your audio system's volume is set to the
desired level.
Check that neither the transmitter nor receiver is muted.

I have connected the sound from the TV wirelessly with my
audio installation but the sound is not synchronised with the
picture.
Your TV needs more time to construct the picture than it does to
play the sound.
The sound from your TV is therefore played slightly later so that
both picture and sound are synchronised.
For the best result, connect the Audio Anywhere transmitter to the
audio output on your TV and not to the audio output on your set-
top box or satellite receiver.
If you connect the transmitter to the headphone output, the TV's
speakers will be disconnected and you can continue to use the TV
remote control to regulate volume via the Audio Anywhere 625.
8 © MARMITEK