Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
COMPLETING THE INSTALLATION
1. Re‐install the filters.
2. Plug in the 3‐tong plug in the properly grounded outlet that you was installed in the cupboard
above the cooking surface
3. Verify the operations of the hood and the lamps. See section "OPERATING THE HOOD". If the
hood does not operate, determine if a circuit breaker has opened or a home fuse is blown.
Disconnect the power source and inspect the wiring connections.
NOTE: To get the most out of the new range hood, read the following section, "Operating the hood".
OPERATING THE HOOD
The range hood is designed to extract smoke, fumes and odors from the cooktop area. For best results, turn
on the fan before starting cooking and let it run for several minutes after cooking is complete in order to allow
cooking odors, steam or smoke to evacuate from the kitchen.
The hood controls are located on the center front of the hood body.
A. Fan and Light Controls
B. Filter
C. Filter handle
D. LED lamp housings
D
A
B
C
Publicité
Chapitres
Table des Matières
