Opening Dimensions - AVG MONTANA Instructions D'installation Et Guide De L'usager

PREPARING THE CUT‐OUT
1. Using a jigsaw or reciprocal saw cut an opening in the bottom of the cabinet, inside the frame
For frameless cupboards, a ¾" (1.9 cm) front and rear edge is required to form a frame in the
NOTE:
bottom of the cabinet. A ¾" (1.9 cm) thick support rod (not included) may be required for certain types of
cabinets.
OPENING DIMENSIONS
Model AVM-278PS
A = Opening in the cupboard
Model AVM-368PS
Remove the decorative panel from the range hood.

Cut a hole in the bottom of the cabinet, using the dimensions shown in the table

above, according to the model.
Insert the hood in the cabinet and secure with the (4) mounting screws from the

inner side of the range hood. Make certain that the hood is secure before releasing.
Note: Wood blocking might be necessary if there is no frame to secure the
mounting screws.
Replace the decorative panel.

2. Complete the closet preparation according to the instructions for the type of home evacuation. Determine the
location of the ventilation openings and cut out the openings in the cupboards, walls and / or soffits.
¾"
¾"
23
3/4"
26½"
34½"
.
10¾"
¾
"
10¾"
''