WARNING
PLEASE MAKE SURE NOT TO DO DAMAGE ELECTRICAL WIRING OR OTHER NON‐APPARENT EQUIPMENT
WHEN CUTTING. WHEN CONSTRUCTING THE CARPENTRY, ALWAYS FOLLOW ALL APPLICABLE BUILDING
CODES AND STANDARDS.
WARNING
: AT LEAST TWO (2) PERSONS ARE NECESSARY TO LIFT AND POSITION THE HOOD.
WARNING
: BE CAREFUL WHEN INSTALLING THE HOOD AS IT MAY HAVE SHARP EDGES. WE RECOMMEND
THAT YOU WEAR PROTECTIVE GLOVES.
CAUTION
: DO NOT REMOVE THE PROTECTIVE PLASTIC FILM COVERING THE HOOD AT THIS STAGE.
LOCATION PREPARATION
It is recommended that the exhaust system be set up before the hood is installed.
Before cutting, make sure that the separation distances for the fittings in the walls and/or roof are adequate.
Before mounting the cabinet to the wall, cut the opening in the bottom of the cabinet beforehand.
1.
Disconnect the power source.
2.
Determine the method of discharge to be used: discharge through the wall or roof.
3.
Choose a flat surface for the hood assembly. Place the protective material on this surface.
4.
Using two or more people, lift the hood over the covered surface.
22