Reely Cyclone Multi Notice D'emploi page 60

Nod trimming:
If the quadrocopter drifts forward, reduce the speed until the quadrocopter once more stands safely on its landing
legs. Now press the trim button for the nod function (see also Fig. 1, Pos. 3) multiple times downward, i.e. toward
your body.
Then carefully push the pitch stick forward again and check whether the adjustment was sufficient. Repeat the proce-
dure until the model does not show any tendency to drift forward.
If the quadrocopter wants to drift backward, press the button for the nod function upward or away from your body.
The change of the roll trimming can be followed at the trim indicator (see Fig. 4, Pos. 8) in the display. Unlike
the yaw trimming, the value for the nod trimming is automatically saved and does not have to be readjusted
every time after you turn on the transmitter.
Pitch trimming:
You should have the trim button for the pitch function (see Fig. 1, Pos. 17) set in the centre position. The electronics
in the quadrocopter do not correctly recognise the bottom setting of the joystick for the pitch function and the built-in
protective circuit thus does not allow the motors to turn on.
60
Figure 16