Machine Charging - Numatic CRO 8055 Notice Originale

Machine Charging

!
As the machine is used and the batteries are discharged, the meter lights will go out from right to left.
Battery charge level is full.
50-100%
Machine charging point, above footplate.
The large capacity gel batteries are sealed for life and are totally maintenance free.
The on-board charger automatically monitors the charging process and will switch off when the batteries are fully charged.
NOTE: The charging lead supplied with your machine may differ than the lead shown.
Once the charging lead has been connected the display panel will show 'INHIBITED'.
The battery charge indicator display lights will flash in unison and the machine will not operate.
Charging indicator (see page 30).
To ensure a full charge, the machine should be left until the charging indicator shows green.
Once fully charged, disconnect the charging lead from both the power supply and the machine.
NOTE: Charger viewing panel only available on certain models.
28
www.numatic.co.uk
Always ensure that the machine is switched off prior to charging.
Charge machine when 3 red lights are illuminated.
20-50%
Insert country specific charging lead.
When 3 red lights flash all cleaning functions
will disable, charge immediately.
0-20%
Red charging indicator illuminates when charging.
!