Stihl GS 461 Notice D'emploi page 32

English
The following information applies under normal operating conditions. The specified intervals must be
shortened accordingly when working for longer than normal or under difficult cutting conditions
(extensive dust, etc.).
Cylinder fins
Carburetor
Spark plug
All accessible screws, nuts and bolts (not adjusting
2)
screws)
Spark arresting screen (present only in some
countries)
Exhaust bore
Safety information labels
1)
STIHL recommends STIHL servicing dealers
2)
During initial use, tighten the cylinder block screws after 10 to 20 hours of operation
3)
If diamond abrasive chain is mounted or changed
30
clean
Check idle adjustment – chain must not rotate
Set the idle speed
adjust electrode gap
replace after 100 hours' operation
retighten
1)
check
1)
clean or replace if necessary
decarbonise after 139 hours of operation, subse-
quently after every 150 hours of operation
replace
X X
X X
X
X
X
X
X
X
X
GS 461