Stihl GS 461 Notice D'emploi page 14

English
Fit diamond abrasive chain
Fit the diamond abrasive chain
N
starting at the nose of the guide bar
1
1
4
Position the guide bar over the
N
bolts (1) – align drive links so that
the position lines up with the symbol
(arrow)
WARNING
If the drive links are not directionally
aligned one behind the other correctly,
the diamond abrasive chain and chain
sprocket will be damaged beyond repair.
12
Position the right locating hole (2)
N
over the peg of the tensioner slide –
simultaneously place the diamond
abrasive chain over the sprocket
wheel (3)
Turn screw (4) to the right until there
N
is very little diamond abrasive chain
sag on the underside of the bar and
the lugs of the drive links engage in
the bar groove
Refit the chain sprocket cover – and
N
then screw on the nut by hand until
it is fingertight
Go to chapter "Tensioning the
N
diamond abrasive chain"
Moving the guide bar
Only move the guide bar if the diamond
abrasive chain cannot be tensioned
properly.
Removing the chain sprocket cover
N
Remove guide bar with diamond
N
abrasive chain
Fit the diamond abrasive chain
N
starting at the nose of the guide bar
1
1
4
Position the guide bar over the
N
bolts (1) – align drive links so that
the position lines up with the symbol
(arrow)
WARNING
If the drive links are not directionally
aligned one behind the other correctly,
the diamond abrasive chain and chain
sprocket will be damaged beyond repair.
Position the left locating hole (5)
N
over the peg of the tensioner slide –
simultaneously place the diamond
abrasive chain over the sprocket
wheel (3)
Turn screw (4) to the right until there
N
is very little diamond abrasive chain
sag on the underside of the bar and
the lugs of the drive links engage in
the bar groove
Refit the chain sprocket cover – and
N
then screw on the nuts by hand until
they are fingertight
Go to chapter "Tensioning the
N
diamond abrasive chain"
GS 461