Publicité
Les langues disponibles
Les langues disponibles
S w i t c h i n g o f O n / O f f a n d
s e t t i n g o f t h e f a n l e v e l –
A I R S w i t c h
The B 300 is switched on or off by pressing the
AIR-button twice. By repeatedly depressing the
switch, the different fan modes can be changed
-STANDBY:
The humidifier is switched off and
without function. Attention: The unit
still receives power.
-LOW:
The fan runs on the lowest output
level. The noise level is optimized
-HIGH:
The fan runs on the highest output
level, for a maximum output of humi-
dity and air purification.
-AUTO:
The fan runs automatically according
to the performance requirements,
which is controlled by the actual
room humidity.
If the AIR-key is pressed, the symbol on the indica-
tor display starts to blink and, after pressing the
switch again, jumps to the next operating mode. By
depressing the AIR-switch again, the status can be
changed to the next mode. In this condition, the
symbol blinks until the desired status is reached
and for 2 seconds, another setting was not selec-
ted. After that, the symbol no longer blinks, and the
selected operation mode is performed. Please note
that when the AIR-key is depressed the first time,
only the setting mode is started and the operating
mode does not change. Only by depressing the AIR-
switch again, the operating modus is changed.
C h a n g i n g o f t h e –
H U M I D I T Y- S w i t c h
If the unit is turned on, with the humidity keys +/-
the desired relative humidity can be changed
upward or downward. During the pressing of the
keys "+" or "-" the indicator jumps from the actual
room humidity to the desired value according to
the setting. By repeatedly pressing the + or –
switch, the value is accordingly changed. If the
desired value is adjusted, the indicator display
jumps back after few seconds to the actual room
humidity and the new desired value was recorded
and stored.
14
F u n c t i o n " S w i t c h / k e y l o c k "
To lock the control keys for children or strangers,
to disable the use of the operating panel, is inte-
grated. It is switched on and/or deactivated by
simultaneous pressing of the 3 keys (AIR KEY
and the two HUMIDITY keys) for 3 seconds. If the
key disabling device is activated and a key is
pressed, all control elements in the display blink.
The key lock must be deactivated. Only after
pressing the 3 keys again, the settings can be
changed.
S a f e t y o f t h e u n i t
The unit is equipped with two reed switches,
which, when opening the casing of the unit, swit-
ches via the control all components of the B 300
off. The disconnection via the reed switch is sig-
naled via a flashing STAND-BY indicator. Only if
the casing is completely closed, the Standby indi-
cator turns off and the air humidifier takes up
again operations.
F i l l i n g t h e t a n k
To fill the water reservoir of the B 300, switch off
the unit as described above. The indicator in the
display helps you to determine the correct level.
Now open the lateral filler flap on the right or left
side (see fig. 1). Grab the flap at the grip above
and pull it up to the stop outward. Now you fill up
the tank to the water level as indicated on the
display, using a suitable container (e.g. watering
can or similar).
It is important that you do not spill water around
the unit or overfill the humidifier. The exiting
water can damage your furnishings or your unit.
Disconnect the mains plug before opening the equipment!
Publicité
