Condair Brune B 300 Manuel D'instruction page 13

S a f e t y I n s t r u c t i o n s /
Wa r n i n g
●
Children do not recognize the dangers, which
can develop while handling electrical applian-
ces. Therefore do never leave children unsu-
pervised when running electrical appliances.
●
The unit may be operated only by authorized
persons.
●
Never operate an appliance with defective
power input.
●
Make sure that electrical parts do not come
into contact with water.
●
The appliance is not exposed to influence of
the weather (rain, snow, frost); also
●
do not operate the unit with wet hands.
●
The unit is set up stable and horizontally onto
the ground.
●
When absent for a longer time, always pull
the power supply plug or ensure that the
power supply is disconnected.
●
Before cleaning, always first pull the power
supply plug.
●
Never pull the unit or the power cable at the
power inlet, when pulling the power supply
plug out of the socket.
●
Never move the unit in a filled condition.
Water can exit and cause damages to the unit
or furnishings.
●
Service work, for which tools have to be used,
may only be performed by the authorized per-
sonnel.
S e t u p / L o c a t i o n
●
Open the packaging and remove all packaging
parts from the humidifier.
●
Setup the unit onto an even,
horizontal surface.
●
For an optimal function, the unit may be set
up near a heat resource. However, the tempe-
rature in that area should not exceed 70° C.
●
Check the unit for any possible transportation
damages.
●
Check whether the delivery is complete, and
that all parts belonging to the unit are fitted
properly.
O p e r a t i n g y o u r u n i t
Before operating your unit, you should ensure
that all parts are installed appropriately and that
the water reservoir is filled. Please proceed as
follows:
Disconnect the mains plug before opening the equipment!
P o w e r S u p p l y
Check whether local mains voltage is the same
as the one on the identification label. The identi-
fication label is located above the power/net inlet
cable and below the fan motor. To locate the
label, you first have to remove the outer case of
the unit.
O p e ra t i n g t h e Hu m i d i fi e r B 3 0 0
The operating display of the B 300 informs you
about the current condition of the unit. You can
read the room humidity, the set fan level, and the
water level. By using the switches + /- and AIR,
you can input the settings for your unit.
The indicator display and setting of the relative
humidity takes place in 5% increments.
Therefore, the values may deviate when using
other control devices. At 3% and 8%, the display
jumps over to the next higher value (e.g. actual
humidity = 43% corresponds to =45%)
The user can, to a minor degree (+/- 5%), cali-
brate the display accuracy. Read more about this
in the Paragraph „Adjusting the humidity
Indicator" (p. 17).
13