VERITAS JSB21 Guide De L'utilisateur page 5

Table des Matières

Publicité

RECOMMENDATIONS
You're just starting off on your machine...
Do you have any problems?
Check the following sections:
— Changing or fitting the needle (page 31)
— Winding the spool (page 21)
— Fitting the spool (pages 25)
— Adjusting the bottom tension (page 101)
— Maintaining the machine (page 85)
— The graduated knob with settings 1 to 9 situated top left must be on 5.
— The top thread and the bottom thread must be of the same thickness; before starting to sew, pull them together towards the back.
— The needle has a flat side, which must be facing towards the back of the machine.
— The needle must be raised before you select your stitch.
— The top thread is threaded from right to left, taking care never to cross the threads (see diagram in the top lid).
— Put the thread through the eye of the needle from the front (i.e. from front to back).
It is recommended that you keep this packaging so that the machine can be transported safely if necessary.
English
5

Publicité

Chapitres

Table des Matières
loading

Table des Matières