Adjusting The Brake Spur; Starting The Engine - Stihl MH 610 Manuel D'utilisation

Transport wheel in working position:
● Remove spring clip (1) and pin (2) at
transport wheel (3).
● Fold transport wheel (1) upwards and
fasten with pin (2) and spring clip (3).
● Check the transport wheel for secure
seating.
28

11.5 Adjusting the brake spur

The brake spur is used to regulate the
resistance and consequently the speed of
propulsion during tilling. The brake spur
can be adjusted in six stages for better
control.
Attention!
The brake spur can slip out. Hold
the brake spur during adjustment.
Adjusting the brake spur:
● Place the transport wheel in the working
position. ( 11.4)
Tilt the tiller forwards and make sure
that the machine is stable and safe.
● Loosen bolt (1) so that brake spur (2)
can be adjusted.
● Pull out pin (1) and spring clip (2).
● Move brake spur (3) to the desired
position and fasten once again with
pin (1) and spring clip (2).
● Clamp brake spur (1) with bolt (2).

11.6 Starting the engine

● Set the On/Off switch to the I
position.( 8.1)
0478 404 8800 A - EN