Technical Specifications - Stihl MH 610 Manuel D'utilisation

p.p.
Matthias Fleischer, Research and
Development Division Manager
p.p.
Sven Zimmermann, Quality Division
Manager

18. Technical specifications

MH 610.0
Serial number 6250
Engine, design 4-stroke com-
bustion engine
Starter Rope start
Engine type STIHL EHC
600.0
Displacement 212 ccm
Nominal output at 4,4 - 3600
nominal speed kW - rpm
Fuel tank 3,6 l
Tool 4 hoe elements,
2 plant protec-
tion discs
Hoe set diameter 31 cm
In accordance with Directive 2006/42/EC:
Measured sound
power level L 98,3 dB(A)
WA
0478 404 8800 A - EN
Uncertainty K 3 dB(A)
WA
L + K 101 dB(A)
WA WA
Sound pressure level
at workplace L 86 dB(A)
pA
Uncertainty K 3 dB(A)
pA
Specified vibration characteristic in
accordance with EN 12096:
Measured value a 6,90 m/s
hw
Uncertainty K 2,76 m/s
hw
Measurement in accordance with
EN 20643
Drive 2 forward gears
1 reverse gear
Length 163 cm
Width 85 cm
Height 105 cm
Weight 60 kg
18.1 REACH
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.
19. Troubleshooting
If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
@ See engine instruction manual.
2
2
Fault:
Engine not starting
Possible cause:
– On/Off switch set to Off position
– No fuel in tank; blocked fuel line
– Inferior, dirty or old fuel in tank
– Spark plug socket detached from spark
plug; ignition lead not properly fastened
to socket
– Dirty or damaged spark plug; incorrect
electrode gap
– Dirty oil bath air filter
– Engine flooded due to several starting
attempts
Remedy:
– Set On/Off switch to On position (
– Fill fuel tank (
Clean fuel lines ( )
– Use fresh, good quality fuel (unleaded
petrol) ( 7.15);
Clean carburettor ( )
– Connect spark plug socket (
Check connection between ignition lead
and socket ( )
– Clean/replace spark plug (
Adjust electrode gap ( )
– Clean/replace oil bath air filter (
– Remove spark plug and dry, set On/Off
switch to Off position and pull recoil
starter rope repeatedly with the spark
plug removed (
8.1)
7.15);
);
), ( );
), ( )
)
35