Jonsered FC2245 Manuel D'utilisation page 55

Maintenance
Examine the transport guard for damage and make sure that it can be attached
correctly.
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the air filter. Replace it if it is damaged.
Tighten nuts and screws.
Examine the starter and the starter rope for damages.
Examine the vibration damping units for damages and cracks.
Examine the spark plug. Refer to
Clean the cooling system.
Clean or replace the spark arrester screen.
Clean the external surface of the carburetor and the area around it.
Make sure that the bevel gear is filled to ¾ with grease.
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if it is necessary.
Examine all cables and connections.
Examine the clutch, clutch springs and clutch drum for wear. Replace it if it is ne-
cessary.
Replace the spark plug.
Clean or replace the spark arrester screen.
Lubricate the drive shaft.
To adjust the idle speed
Your JONSERED product is made to specifications that
decrease harmful emissions.
1. Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
2. Adjust the idle speed with the idle speed screw T
which is identified with "T" mark.
3
Replace the vibration damping unit after each season or at a minimum of one time each year.
4
At an interval of 3 months.
1145 - 001 - 09.04.2019
To examine the spark plug on page 59 .
4
Daily
3
a) Turn the idle speed screw T clockwise until the
cutting attachment starts to rotate.
b) Turn the idle speed screw T counterclockwise
until the cutting attachment stops.
WARNING: If the cutting attachment
does not stop when you adjust the idle
speed, speak to your servicing dealer.
Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
55