Jonsered FC2245 Manuel D'utilisation page 41

5. Press the throttle trigger (B) and make sure that it
goes back to its initial position when you release it.
6. Start the engine and apply full throttle.
7. Release the throttle trigger and make sure that the
cutting attachment stops.
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the engine.
2. Do a visual check for damages, for example cracks.
3. Replace the cutting attachment guard if it is
damaged.
1145 - 001 - 09.04.2019
To do a check of the vibration damping system
The vibration damping system decreases vibration in the
handles to a minimum which makes the operation
easier.
1. Stop the engine.
2. Do a visual check for deformation and damage for
example, cracks.
3. Make sure you attach the elements of the vibration
damping system are correctly.
To do a check of the safety-release mechanism
WARNING: Do not use a harness with a
defective safety-release mechanism.
The safety-release mechanism lets the operator remove
the product quickly from the harness if there is an
emergency.
1. Stop the engine.
2. Do a visual check for damages, such as cracks.
3. Release and attach the safety-release mechanism to
make sure that it operates correctly.
41