Jonsered FC2245 Manuel D'utilisation page 44

2. Put the throttle handle onto the right side of the
handlebar.
3. Align the screw hole in the throttle handle with the
hole in the handlebar.
4. Put the screw into the hole at the bottom of the
throttle handle and through the handlebar.
5. Install and tighten the nut.
To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration.
2. Tighten the knob lightly.
3. Put on the harness and hang the product from the
suspension point.
4. Adjust the handle to put the product in a correct work
position.
5. Tighten the knob fully.
44
To set the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
touches the battery.
3. Turn the handlebar around the shaft.
4. Tighten the knob.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 62 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
To attach the guard extension
CAUTION: Use the guard extension when
you use a trimmer head/plastic blade. Do
not use the guard extension when you use a
grass blade.
1. Put the guard extension in the groove of the cutting
attachment guard.
2. Put the guard extension into position on the cutting
attachment guard with the 4 locking hooks.
Accessories on
1145 - 001 - 09.04.2019