Publicité
Step 2. Group LE reinforce-
ments with the A tabs
aligned, make sure the plas-
tic reinforcements lay side
by side.
Step 3. Lay wing on its side
and Strap LE...Note the
glider is NOT folded in half; it is
folded with a complete concer-
tina from tip to tip. It is really
important to not stress the
middle cell or bend the plastic
too tightly.
Step 4. Group together the
centre of the wing.
Step 5. Carefully zip up the
saucisse pack without trapping
any material or lines.
Step 6. Make the first fold after the LE reinforcements. Do not
fold the plastic reinforcements, use 3 folds around the LE.
IMPORTANT: Do NOT lay the wing flat on the ground before
packing the glider, this will cause abrasion damage to the
top surface as you pull the glider towards the middle. AL-
WAYS pack from a mushroom or lift the wing off the ground
when gathering the wing and grouping the leading edge.
Important: Do not fold the glider in the centre, you will
bend the plastics, instead pack the wing with a full concer-
tina method from tip to tip before packing into the stuff sac.
15
=
=
Publicité
